3DMK Posted November 4, 2011 Report Share Posted November 4, 2011 Hi Eduard, Is there any way of stopping the Stoping Meta-mesh from updating when it shouldn't need to such as when you changes leaves. I always end up wanting to tweak things AFTER I have made a meta-mesh even when I try to leave that till the last. Turning on manual update whilst tweaking is not helpfull in this instance as it still does the meta-mesh once you update. Thanks again for your time Jamie Quote Link to comment Share on other sites More sharing options...
Eduard Posted November 4, 2011 Report Share Posted November 4, 2011 Hi Jamie, Ok, we'll try to improve the management of updating the calculation mesh builders... At this point, you can just copy your metamesh builder, then convert the new metamesh to the cylinder mesh, and the original metamesh turn off. After you finish setting all the other builders, turn off the cylinder mesh, and turn on your original metamesh Cheers Quote Link to comment Share on other sites More sharing options...
3DMK Posted November 9, 2011 Author Report Share Posted November 9, 2011 Hi Jamie, Ok, we'll try to improve the management of updating the calculation mesh builders... At this point, you can just copy your metamesh builder, then convert the new metamesh to the cylinder mesh, and the original metamesh turn off. After you finish setting all the other builders, turn off the cylinder mesh, and turn on your original metamesh Cheers Thanks for the Tip Eduard.....I didn't know you could convert the meta-mesh back to a cylinder...that should save time Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.