Nenad Posted February 19 Report Share Posted February 19 Hi. I've just purchased some Cedrus models from Maxtree. We need to cut/trim the lower branches of the trees. The procedure should be straightforward, but when rebuilding the mesh, the result is the same as the original mesh, although I can clearly see that the paths were erased. Any help would be greatly apretiated. Quote Link to comment Share on other sites More sharing options...
Eduard Posted February 19 Report Share Posted February 19 54 minutes ago, Nenad said: Hi. I've just purchased some Cedrus models from Maxtree. We need to cut/trim the lower branches of the trees. The procedure should be straightforward, but when rebuilding the mesh, the result is the same as the original mesh, although I can clearly see that the paths were erased. Any help would be greatly apretiated. Hello Nenad, Is this happening in version 1.9.9 SP12? Please send me this model, I'll check it out. Thanks! Quote Link to comment Share on other sites More sharing options...
Nenad Posted February 19 Author Report Share Posted February 19 2 hours ago, Eduard said: Hello Nenad, Is this happening in version 1.9.9 SP12? Please send me this model, I'll check it out. Thanks! Yes. I'm not saying it's a bug. I'm not an active GrowFX user. Perhaps it's how the whole thing is setup. I will send the model. Most probably it's just one thicker to enable/disable, but I don't know how. Quote Link to comment Share on other sites More sharing options...
Eduard Posted February 19 Report Share Posted February 19 Yes, I understand. Send me the model, you can email it to support@exlevel.com, and I'll take a look and show you where and what to change. Thanks! Quote Link to comment Share on other sites More sharing options...
Nenad Posted February 20 Author Report Share Posted February 20 Just sent you an email. If you can take a look today it would be great! Thank you. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.