Jump to content

Recommended Posts

Hi Eduard...and all you out there,

 

I'm not sure what settings to use for the leaves in this ticky creeper? In fact, I don't really understand a lot of the distributor settings and end up just playing around until it looks right. I usually use circular leaf distributor, but in this case should it be angular?

 

I have switched off all my Direction modifiers until it looks right and then I will add variation with them.

 

Please help! Unless you think I am on the right path...

 

Thanks a mil,

Terri

 

 

 

ticky settings.JPG

green-creeper-plant-growing-on-a-brick-wall-DYY94J.jpeg

Share this post


Link to post
Share on other sites

Hi Terri,

 

If you're using the Angular type, I recommend to set the Angle bend = 0, so that you can use the Angle divergence to set the angle between adjacent leaves.

Also use the Vector Orientation modifier with the Another target surface option, and pick your wall as the target surface, so that the leaves are always directed away from the wall.

Hope this helps.

 

Thanks!

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...